Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.
Kit 1 Installation Guide
This is to show you a step by step guide on how to install Kit 1.
In this guide I have used all parts that you get from Kit 1 and installing them onto a wooden block that I have already pre-drilled a hole in.
Step 2
Separate the lampholder into its 3 pieces by unscrewing the shade ring and lock ring, leaving you with the cap, the connection unit and the skirt.
Then take the cap of the lampholder and screw it onto the thread of the backplate.
-
Cap (Bottoms Section)
-
Connection Unit
-
Skirt (Top Section)
-
Lock Ring
-
Shade Ring
Separate the lampholder into the following parts:
Step 5
Carefully push the connection unit into the cap of the lampholder and place the top section (the skirt) onto the lampholder, ensuring the indents line up.
Finally, screw the lock ring and shade ring onto the lampholder.
Note: The copper tag is to sit over the indent on the lampholder so it is slightly visible.
