How can we help?

Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.

< All Topics
Print

Kit 33 Installation Guide

PostedMay 9, 2024
UpdatedAugust 5, 2024
ByRichard Hobbs
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
Views56

This is to show you a step by step guide on how to install Kit 33.

Kit 33 is intended to be used with any lighting 10mm fixing point. For this guide I have used all the parts that you get from Kit 33 and installed them onto a Jack Daniels bottle.

Please Note

This kit does not come with any fixing point i.e. a rubber bung, as used in this guide. So please ensure you already have a fixing point on the item you are using with this kit before starting.

 

Step 1

Take the bung and install it into the bottle, please see the following video on how to install the bung: VIDEO

 

Step 2

Finally, add the 2 shade rings onto the lampholder along with a shade if required.

 

Step 3

Take the side entry cord grip and screw it onto the bung that was installed in step 1.

 

Step 4

Separate the lampholder into its 3 sections and screw the cap onto the cord grip. Tighten the screw inside the cap of the lampholder to ensure that it is securely locked in place.

 

Step 5

Take the cap and screw it onto the side entry cord grip.

Then tighten the small screw that's located on the inside of the cap, this will lock the cap to the side entry cord grip.

 

Step 6

Take the cable cord set and carefully push it through the side of the cord grip and out through the lampholder.

Note: You may need to loosen the black grub screw to allow the cable to pass, do not tighten this screw back up yet!

 

Step 7

Using a pair of pliers, double over the ends of the cable.

 

Step 8

Take the connection unit of the lampholder and connect the Neutral (Blue), the Live (Brown) and the Earth (Green/Yellow) into the correct connection points, as shown below.

  Caution If in any doubt please seek professional advice.

 

Step 9

Carefully push the connection unit into the base of the lampholder ensuring the indents align up (see first image below).

 

Step 10

Screw the skirt of the lampholder onto the cap until you hear several clicks, this is the insert locking into place.

 

Step 11

Tighten the black grub screw on the side entry cord grip and screw the 2 shade rings in place.

 

If you need to remove this lampholder then please view our "how to unlock your lampholder" guide.

Learn More

This now completes the installation of KIT 33

 

Was this article helpful?
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
5
Please Share Your Feedback
How Can We Improve This Article?
Scroll to Top