How can we help?

Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.

< All Topics
Print

Kit 15 Installation Guide

PostedAugust 2, 2024
UpdatedAugust 5, 2024
ByRichard Hobbs
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
Views10

This is to show you a step by step guide on how to install Kit 15.

In this guide I have used all parts that you get from Kit 15 and installing them onto a wooden block that I have already pre-drilled a hole in.

  • 1x BC | Bayonet Cap Switched Lampholder
  • 1x Cable Cord Set
  • 1x Backplate
  • 1x Backplate Cover
  • 5x Wood Screws
  • 1x Cord Grip
  • 1x Extender (if purchased)

Step 1

Feed the cable cord set through your light fitting ensuring not to damage it as you push/pull it through. Ensure you leave this loose so you can adjust the length when on step 4.

Next, place the backplate over the cable and fix it down onto your wooden lamp using the supplied screws, then place the cover over the top.

Step 2

Take the extender (if purchased) and simply screw it on top of the thread on the backplate.

Step 3

Separate the lampholder into its 3 pieces by unscrewing the shade ring and lock ring, leaving you with the cap, the connection unit and the skirt.

Then take the cap of the lampholder and screw it onto the extender or onto the thread of the backplate if you have no extender.

  • Cap (Bottoms Section)
  • Connection Unit
  • Skirt (Top Section)
  • Lock Ring
  • Shade Ring

Separate the lampholder into the following parts:

Step 4

Using a pair of pliers, double over the ends of the cable.

Next, wire the cable into the connection unit of the lampholder.

This is done by firstly loosening the screws in the connection unit, then inserting the cable ends into the connection points, ensuring the Earth (Green/Yellow) is in the middle connection.

It does not matter which way around the Live (Brown) and Neutral (Blue) go. Lastly, re tighten the screws, so the cable is securely in place, as shown in the image below.

Warning

If in any doubt, please seek professional advice.

Step 5

Carefully push the connection unit into the cap of the lampholder and place the top section (the skirt) onto the lampholder, ensuring the indents line up.

Finally, screw the lock ring and shade ring onto the lampholder.

Note: The copper tag is to sit over the indent on the lampholder so it is slightly visible.

Step 6

Ensure you use the cord grip on the bottom of the light fitting by putting it across the cable and using the screws supplied to fix it into position, this will ensure the cable cannot be pulled out by accident.

Was this article helpful?
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
5
Please Share Your Feedback
How Can We Improve This Article?
Scroll to Top