How can we help?

Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.

< All Topics
Print

Wiring our E26 lampholders

This guide is to assist you in the installation of the Brass E26 lampholder.

Before you start, please be aware that these lampholders are ONLY designed for the American market and not UK electrical systems.

My knowledge on American wiring is not perfect, but I will show you to the best of my knowledge.

Pieces used in this guide:

Just a quick note the lampholder fixing thread is 1/8″ IP thread and screws onto our 10mm threads well with a slight wobble, however as this Lampholder has a locking screw it works perfectly and holds very tight.

In this guide we will be fixing the E26 lampholder onto a wooden base for example.

If you are just needing to know how to install the lampholder then ignore step 1

  • Bottom section (Base)
  • Cardboard isolator
  • Lock Ring

  • Connection Unit
  • Top section (skirt)

Separate the lampholder which consists of the following items:

 

This now completes the installation of the E26 lampholder.

 

Notice

Please note, this information has been taken from an article online, We are not fully up to date with American wiring and regulations, these may change without notice. We recommend in contacting an American Electrician for electrical advice.

Was this article helpful?
0 out of 5 stars
5 Stars 0%
4 Stars 0%
3 Stars 0%
2 Stars 0%
1 Stars 0%
5
Please Share Your Feedback
How Can We Improve This Article?
Scroll to Top