Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.
Wiring A BC Un-Switched Lampholder
Before we get to the wiring of the lampholder below is a quick video on how to separate the lampholder.
Once you have the unit separated, you can move onto the wiring of the lampholder below.
Please note that this guide is using a 10mm entry lampholder however the concept is the same on different models.
Step 1
Ensure you have fixed the cap or base of the lampholder to the fixing point.
You can always add a spot of super glue to the thread to stop it rotating. Once the flex has been stripped twist the individual wire and fold in half to give a good connection.
Â
Step 2
Connect the earth wire (Green/Yellow) to the earth point. This image shows the earth point on the side of the cap.
Â
Step 3
Connect the Brown and Blue to the connection part of the lampholder.
Make sure the screws holding the Brass pins are also tight. Ensuring the screw is clamping on the striped part of the cable and not the outer jacket.
Â
Step 4
On the side of the connection part there is a indent, ensure this is lines up with the same on the cap.
Sit the connection part into the cap and make sure there are no trapped wires.
Â
Step 5
