How can we help?
Welcome to our Support Portal. Search for answers using the search box below, or create a support ticket if you cannot find your answer.
Assembly and wiring of our black twin inline foot switch
-
Back Body
-
Front Body
-
Body Screws
-
Neutral Block
-
Switches
-
Switch Covers
This is a quick step-by-step guide on how to assemble and wire our black twin inline foot switch.
In this example, i will be showing you how to wire this twin switch using 1x feed and 2x outputs.
Any electrical work should be carried out by a competent person.
This switch comes in pieces and consists of the following items:
Step 1
Take the neutral block and place it into the centre of the switch body.
Step 2
Wire the switches as show below. This configuration of wiring is 1 feed and 2x outputs, you can have 2 separate feed and 2 output if you wish.
Feed is the bottom cable and the 2x outputs are the 2 cable at the top.
Step 3
Once wired, and you are happy with the connections and configurations, place the cord grips over the cables then using the screws, screw them down to hold the cables into a firm position.
Finally place the switch caps onto of the switches.
Â
Step 4
Once the caps are resting on top, carefully place the top cover over the top, note the cover will only go one way as the switches are off-centre slightly.
Step 5
Finally, flip the unit over and place and tighten the 2x cover screw into position.
